Redsbaby Bounce Bedienerhandbuch PDF herunterladen (Seite 11)

3. Feed the top end of the bassinet lining into the circular frame by

gripping one side of the edge and gently feeding into the frame channel.

Stop when approximately 5cm of the edge has been fed into the frame.

4. Repeat this on the opposite side, again feeding in approximately 5cm

of the edge into the channel.

5. Continue to slowly feed small sections of each side of the lining into

the frame until the lining is completely in the channel.

6. Secure the Velcro tabs around the top end of the circular frame.

7. Place the bassinet board in the bottom of the bassinet liner. Secure

using the Velcro tabs located at the top and bottom ends of the bassinet

liner.

8. Place the bassinet mattress in the bassinet liner.

9. Zip on the bassinet apron.

10. If desired, attach the bassinet bumper by aligning the ends of the

bumper with the two openings on the circular frame. Gently push down

into place until your hear and feel a ‘click’ on both sides. Check the

bumper bar is locked securely.

11. If desired, attach the canopy by following the instructions on page 17.

12. To place on the frame, push down gently until you feel and hear a

‘click’.

1 2

3 4 5

PRESS

THUMB

HERE

PRESS

THUMB

HERE

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Keine Kommentare

Redsbaby Bounce Bedienerhandbuch Seite 11